Flux Ircam Verb Session (Produto digital)

Ircam Verb Session, is based on the very same fine technology used in the acclaimed Ircam Verb, tailored for simplicity providing a fast paced workflow for achieving the perfect result instantly, presenting the ultimate high-end reverb solution for your traditional mono/stereo audio production, whether you’re a seasoned session engineer or a demanding broadcast and post-production mixer.
The Decay Time, is the duration of the reverberation tail in seconds, the time it takes for the reverberated sound to die out. In technical terms this is often referred to as the RT60 factor, the time at which the response of the reverberation to an input signal goes below -60dB of attenuation.
The Room Size is a meta parameter used to quickly perform a homogeneous set of parameters for the early reflections part (early + cluster). These parts are particularly important to achieve the “room” feeling of the desired space. It adjust the time structure of the whole reverberation (early-min, early-max, cluster-min, cluster-max, reverb-start).
The Pre Delay controls the time at which the reverberation portion of the effect starts to be noticed, with respect to the DIRECT signal. Increasing this helps to distinguish between direct and effected sound and preserve intelligibility, especially with large decay times and room sizes which would otherwise drench the audio material in reverberation.
The Filter Section controls the characteristics of the filter applied to the signal fed to the reverberation engine, affecting the overall frequency response, if required.

• Low Freq – Low pass filter frequency cutoff of the corresponding filter section.
• High Freq – High pass filter frequency cutoff of the corresponding filter section