MOOG Werkstatt-01

OSCILLATOR SECTION

• Single VCO w/ frequency control (8Hz to 16KHz)

• Saw and square waveshapes w/ control for square pulse width

• Envelope or LFO selectable Mod Source that can be assigned to PWM or Pitch w/ Amount control

• Ability to PWM the square wave

 

FILTER SECTION

• Classic 4-Pole Moog Ladder Filter w/ Resonance control (20Hz-20KHz)

• Select between the Envelope generator and LFO as Mod Source.

• Polarity switch (+/-) and amount  knob for control of filter cutoff modulation

 

LFO SECTION

• Selectable Square or Triangle waveshape w/ rate control (2Hz-600Hz)

 

VCA/AMP SECTION

• Select between the Envelope Generator or ON (Drone)

 

ENVELOPES SECTION

• Controls for Attack & Decay time w/ Sustain On/Off switch

 

KB SECTION

• One octave low-note priority legato keyboard w/ glide control

 

PATCHBAY

• VCA Input0V to +5V in VCA EG Mode, +/-2.5V in VCA ON Mode

• VCF Input-5V to +5

• VCO LINEAR FM Input +/-2.5V - NOTE: this is an inverting control input

• VCO EXPONENTIAL FM Input -5V to +5V, 1V/Octave trimmable

• LFO CV Input 5V to +5V – NOTE: Negative CV slows LFO more than the panel

• VCF AUDIO InputUnbuffered/Unmixed AC coupled input to VCF

• 2x KB CV Output3V/semitone from 1 keyboard - NOTE: Attenuate for 1V/Octave

• 2x TRIG Output 5 msec pulse, 0 to +5 V signal generated from low-note priority

• 2x GATE Output0 to +5V signal generated from low-note priority

• 2x EG Output0 to +5V signal, Simple ASD or AD type Envelope Generator

• 2x LFO Output -2.5 to +2.5V Triangle or Square wave, selected via LFO Switch

• 2x VCF Output-2V to +2 V signal for audio or CV uses

• 2x VCO Output0V to +5V VCO signal, wave selected by VCO Wave Switch

 

Rear Panel

• AUDIO Output Nominal +/-1.5V Signal

• POWER+12VDC Center Positive w/ 1.2A Wall transformer

• POWER CONSUMPTION 1.8 Watt AVG